Skip to content

For Bulk Enquiries : Get Free Quote

For Bulk Enquiries : Get Free Quote

Polytex

Original price Dhs. 130.00 - Original price Dhs. 140.00
Original price
Dhs. 140.00
Dhs. 130.00 - Dhs. 140.00
Current price Dhs. 140.00
Size: 20L
Color: White
  • Description
  • Product Scope
  • Application Guide
  • Data Sheet
  • Elastomeric acrylic waterproofing and protective coating

    Polytex 10 is a single component, elastomeric, acrylic waterproofing and protective coating. Polytex 10 upon curing forms a tough, flexible and durable coating which is resistant to UV and other weathering agents.

    Properties

    • Single component, easy to apply
    • Protects exposed concrete structures against carbonation and ingress of atmospheric gases and salts
    • Excellent UV resistance
    • Elastomeric- high crack bridging capability
    • Excellent adhesion to most of the substrates
    • Good resistance to dilute acids, alcohol, hydrocarbons, chloride and sulphate ions

  • Recommended use

    Polytex 10 a single component, elastomeric, acrylic waterproofing and protective coating to be used on:

    • Concrete roofs
    • Metal profile roofs.


  • Step by Step
    Surface Preparation

    Concrete Surface: Clean the surfaces which shall receive the coating of all dust, dirt, moss, oil and grease, loose particles, cement laitance and all other deleterious materials which will affect the adhesion of the coating with the substrate. Cracks and potholes shall be repaired with concrete repair mortar from the Polycrete range.

    Metal surface
    : Clean the surface of all rust scales. This can be achieved by wire brushing or grit blasting.

    Priming
    Polytex 10 shall be diluted with 20% water and applied as primer coat on the concrete surface to seal the pores and stabilize the surface. The primer also functions as an adhesion promoter for the top coats. This primer coat can be applied by a brush, roller or airless spray and allowed to dry completely before the application of acrylic coating.

    Application
    Mix the contents of the drum prior to the application to remove any sediment. Polytex 10 can be applied by soft bristled brush, roller or an airless spray. When applying by airless spray then dilute the coating with approximately 5% water to reduce the viscosity of the coating. Apply the first coat of undiluted material at a coverage rate of 1L./m²/coat to get a Dry Film thickness of 0.50 mm. It is important to ensure that each coat has to be cured totally before applying the next coat. The second coat should be applied at right angle to the first at the same coverage rate, to ensure a full unbroken coating to the substrate. For improved strength and flexibility, embed a fibre mesh or a  65 g/m2 non woven geo-textile membrane whilst the first coat is still wet on all corner joints, fillets and pipe penetration joints. Allow the coating to cure fully for 72 hours to achieve its full properties.

    Coverage
    1L/m2/ coat for 0.5mm Dry Film Thickness. Two coats will give a combined thickness of 1.0mm thickness. (approx 10sqm per 20L drum)

    Mixing Proportion
    Ready to use

    Colour and Quantity
    Grey & White in 20L drum.

    Disclaimer 
    The information in this document is given to the best of Polybit's knowledge, based on laboratory testing and practical experience. Polybit's products are considered as semi-finished goods and as such, products are often used under conditions beyond Polybit's control. Polybit cannot guarantee anything but the quality of the product itself.